captainc Posted May 24, 2022 Share Posted May 24, 2022 have not seen this information, but moving the Insteon 994 setup to Polisy I need to install the serial cable, which of course is long gone. I need to set it up very quickly so does anyone have the pinout for the Polisy serial port to the Smarthome 2413s? much appreciated Link to comment
kzboray Posted May 24, 2022 Share Posted May 24, 2022 This one is available https://smartenit.com/shop/plm-serial-cable/ Or build it yourself. RJ45 PIN1 --> RS232 TX RJ45 PIN8 --> RS232 RX RJ45 PIN7 --> GND 3 Link to comment
captainc Posted May 24, 2022 Author Share Posted May 24, 2022 thanks i can make one now. Link to comment
dex Posted August 31, 2022 Share Posted August 31, 2022 Perhaps one of the easiest approaches is to buy the RS232 port with wiring terminal, cut off one end of an ethernet cable and make the three connections needed. Amazon.com: YIOVVOM DB9 Breakout Connector to Wiring Terminal RS232 D-SUB Male Serial Adapters Port Breakout Board Solder-Free Module with case( Female Serial Adapter) : Electronics 5 Link to comment
Recommended Posts