Realting Posted August 25, 2022 Share Posted August 25, 2022 I have been trying to pair the 2844-222 Insteon Motion Sensor to the ISY - getting below message - Cannot determine Insteon Engine - any ideas ? Link to comment
Realting Posted August 25, 2022 Author Share Posted August 25, 2022 I am on Version 4.9.0 and using the ISY994i Link to comment
lilyoyo1 Posted August 25, 2022 Share Posted August 25, 2022 (edited) 30 minutes ago, Realting said: I have been trying to pair the 2844-222 Insteon Motion Sensor to the ISY - getting below message - Cannot determine Insteon Engine - any ideas ? Your address is either typed incorrectly or its not in linking mode during the pairing process. Also, make sure that your UI matches your firmware Edited August 25, 2022 by lilyoyo1 Link to comment
xlurkr Posted August 25, 2022 Share Posted August 25, 2022 16 minutes ago, lilyoyo1 said: Your address is either typed incorrectly I've been caught by 8 vs B before, so check that. -Tom Link to comment
Techman Posted August 25, 2022 Share Posted August 25, 2022 "Cannot determine Insteon engine" is usually associated with poor communications between the device and the PLM. As suggested above, make sure the sensor is in the linking mode. Also try bringing the sensor closer to the PLM Link to comment
larryllix Posted August 25, 2022 Share Posted August 25, 2022 Always factory reset before linking to ISY.Sent from my SM-G781W using Tapatalk Link to comment
Recommended Posts