Ecolink Thermostats 3x

[RedReiter83]

I have 3x Ecolink zwave Thermostats.

All 3 added into eisy controller fine.

The 1st one installed, but was not functionable, then when i checked a couple of days later, it have become functional

But All 3 thermostats show different degrees of information... from full detail and control, (above)to next to nothing.(below)

Have tried re-interviewing them, that is how the 2nd one became functional. But the 3rd one stays the same.

 

Edited November 7, 2023 by RedReiter83
adding request

[RedReiter83]

Any ideas on how to resolve, would be greatly appreciated.

[DennisC]

10 hours ago, RedReiter83 said:

Any ideas on how to resolve, would be greatly appreciated.

Try Synchronize with Interview.

[RedReiter83]

have done this 20-30 times

recently I have relocated my Eisy w/zmatter closer to the middle of the house.

I was able to remove and reinstall one of the problem thermostats, but so for not the other. One of the three, seems to function correctly

[dbuss]

I had a similar problem with my door locks, and like you, relocated my Eisy to a location where they both work. I've found that with some other Z-Wave devices that were not adding correctly if I had them closer to the eisy when adding them, all the nodes appeared. The nodes remained after adding in this manner and moving everything back to the location I wanted them.