Michaelv Posted December 16, 2023 Posted December 16, 2023 I bought the Zwave dongle for my Eisy and an Aotec Motion sensor. All it has is a reset button. I found the "Add a Zwave device" in the admin Console and brought the sensor right next to the PLM. It wont connect. What do I have to do? MV
lilyoyo1 Posted December 16, 2023 Posted December 16, 2023 Zwave doesn't use the plm. Did you follow the instructions in the wiki in regards to removing the device first then adding? Is your sensor close to the zwave dongle?
tlightne Posted December 16, 2023 Posted December 16, 2023 You need to put the motions sensor into inclusion mode first. The documentation that came with the sensor will tell you how to do that.. Once it is in inclustion mode remove it from the zwave network first then include it into the zwave network.
DennisC Posted December 17, 2023 Posted December 17, 2023 16 hours ago, Michaelv said: I bought the Zwave dongle for my Eisy It is not clear from what you wrote, which ZWave dongle did you buy, have you successfully added the dongle, and enabled ZWave in the Configuration tab?
DennisC Posted December 17, 2023 Posted December 17, 2023 46 minutes ago, Michaelv said: The UD dongle. Have you toggled the use Zwave switch in Configuration tab and then rebooted? Is Zwave menu at top of the admin console?
Michaelv Posted December 17, 2023 Author Posted December 17, 2023 So this is an Aeotec Motion Sensor M6001-MTP. The instructions do not say how to put it into communication / inclusion mode. There was just the battery tab to be removed and the LED would flash green / red for about 5 minutes. I assume that it is in inclusion mode when doing that. There is a reset button and if I press that for 5 seconds the lights start flashing again, or, I can remove the battery, replace it and the led flashes red / green again. I have been within 2 feet of the dongle when in this state. I have read the Wiki and whether I try to add or remove it first, the system does not see it.
Michaelv Posted December 17, 2023 Author Posted December 17, 2023 Quote Have you toggled the use Zwave switch in Configuration tab and then rebooted? Is Zwave menu at top of the admin console? I went to the configuration tab and the Z-wave support is selected to on. I did toggle it. there is a Z-wave menu at the top of the AC.
dbuss Posted December 17, 2023 Posted December 17, 2023 The Aeotec Motion Sensor M6001-MTP is attempting to connect when it's flashing red and green. If you use UD Mobile you may want to try and connect it by using the QR code on the device.
tlightne Posted December 18, 2023 Posted December 18, 2023 @Michaelv Go to AC and click on the ZWAVE tab Then click on add ZWAVE DEVICE in drop down menu You should see this: Put the motion sensor in inclusion mode and the Eisy should then see it and add it. It will take several seconds to get it added.
tlightne Posted December 18, 2023 Posted December 18, 2023 Never mind my previous post this is a Zigbee device according to Aoetec ... So add it with the Zigbee tab in AC...
Michaelv Posted December 18, 2023 Author Posted December 18, 2023 Got it. I thought it was Z wave. Thanks
Recommended Posts