Tesla Node Stopped Working

[Panda88]

can you send a debug log.  i am guessing otherwise

[Panda88]

can you send a log file

this is what my mobile app shows

 

[apostolakisl]

I didn't do an update.  I put it in the same slot as the previous, but completely different Tesla node was.  Then did a fresh install of the new one.

I just drove the car and it currently shows good data.  I will see what happens in a bit and send a log.

[Panda88]

Is it acceptable it I only allow update Data (button) on the status page?  It will update data on all pages, but will be a much simpler to implement 

 

[glenn_steiner]

link is bad and is: ttps://github.com/Panda88CO/udi-TeslaEV2/blob/main/README.md

yes, missing an h at the beginning

[Panda88]

I cannot find the bad link - which one are you referring to? I'll try to fix it

[Geddy]

@Panda88 I think it’s the “more info” button on the plugin page. When viewing on a mobile device it asks me if I’m trying to open another app. 

[Panda88]

it does not show in the released note but there have been some updates that did not populate so it may be an older version

[glenn_steiner]

5 hours ago, Geddy said:

@Panda88 I think it’s the “more info” button on the plugin page. When viewing on a mobile device it asks me if I’m trying to open another app. 

Yes.  Thanks for clarifying my comment.  Its the more info button.

[apostolakisl]

I have updated to the latest version and this still is not working.  My car is currently charging and the phone app shows it as charging and currently 75%.  This is what the node says.  I assume "status" should be saying 75%.  And of course the other info should be saying it is charging.  If I click "honk horn", it does honk the horn.  So clearly it is connected in some fashion.

And the climate page shows 0 degrees c in the "node connected" field.  That makes no sense.  My phone app shows exterior temp as 81 and interior temp as 92.  

 

EDIT:  After a bit, not sure how long, it did update to say it was charging, but still reporting 0% status.

 

Edited December 29, 2024 by apostolakisl

[Panda88]

can you send me a log file?

[Panda88]

can you send me a log file?  what version is it reporting?

[someguy]

@apostolakisl:  I had a similar problem recently where none of my data was updating.  I was able to fix it by using the "autheticate" button in PG3x and this fixed the issue.  

[apostolakisl]

I updated the node today and now I am getting an accurate percent on the battery.