Smart lock addition

[Panda88]

Try to install once more.   There was an issue with the install file

[drprm1]

Reinstalled in same slot no change. New install to new slot no change.

Says already running, no log, non functioning.

[Panda88]

It may take a little while to propagate

There is an issue with the zip file so i moved to different approach

[drprm1]

So I wait a while to try install again? Not sure I understand what’s going on with “it may take a while to propagate”

thx

[Panda88]

It has to go through Amazon cloud before changes occur when using a zip file. 

[Panda88]

changed release to 1.3.23 

[drprm1]

Sorry not a developer so not sure what has to go through Amazon cloud. I just assume when I see the correct update number shown that it’s available…Waited a while and not seeing any 1.3.23

[Panda88]

It can take a few hours from what I know

[drprm1]

Just now, Panda88 said:

It can take a few hours from what I know

Great

[drprm1]

Updated and works great 

(Battery still shows -1 while doorbell state shows 99) 😃

Thanks

[Panda88]

Can you send a log again?

[drprm1]

12 minutes ago, Panda88 said:

Can you send a log again?

 

YoLink_1-19-2025_94125_AM.zip

[Panda88]

found the bug - I think the doorbell will update if you press it

It is difficult to test as the LockV2 reports data different compared to the old lock (which I have)

Is it ok if I wait to release a new version - working on getting the dimmer to work in scenes - should be a few days (I hope)

   

[drprm1]

Of course it’s okay to put in next update. 
 

Thanks again