lilyoyo1

Depends on the device mfg. Some only allow 4. Also know that devices activated via association will not update their status in the Isy

As @MrBillpointed out, the upgrade wont work so disregard what I said. Since you wont be able to upgrade, you will probably have to start over. I would recommend copying your programs to ensure you can put them back again the way they are supposed to be. The good thing is, the changed programs will show up in yellow which will make finding them again much easier.

IF motion is switched off and not switched on, THEN wait 1 minute, turn light off. When motion sends off command, the isy will wait 1 minute before telling the light to turn off. If you move in that minute, the program will stop and lights stay on

Backup your Rpi, connect your polisy, choose your backup and restore it

I separate my on and off actions. That way I can have different things happen for different scenarios without worrying about conflicts or other things. Outside of that, you would program the light the way you just wrote it out.

There's a bug right now where this doesn't work. Not sure if it's been fixed in 5.3.3

Does your UI match your firmware? Post your program

You're using the wrong link. You already went to 5.3 so you would use the link for 5.3

There's no Isy database. If the online manual didn't have the information, you'll have to change the settings to see what they do. Unfortunately zwave has a lot of options that manufacturers do not always take advantage of.

Try a different bulb. Phillips warm glow bulbs work really well with insteon

Make sure you choose the launcher link from the 5.3 post that is in the current release and betas subforum.

If you properly cleared your Java cache and used the link from the 5.3 post, everything should match.

Make sure your firmware and UI match. Bring the siren within 3 feet of Isy to add

There's no portal firmware. What did you update from? Did you try admin/admin? Did you follow the directions in the upgrade post?

5.3.3 options tab must be invisible on some screens. Sorta like the invisible type UDI uses with their instructions ?

Then it could work that way.

Probably won't work. Since the commands are being issued outside of the Isy, it won't see the status change to update

Most likely not supported since multi channel is not supported in 4.x. You'll need to upgrade to 5.0.16c. make sure that you READ THE INSTRUCTIONS COMPLETELY, if/when you do

I don't click on links but judging by the information showing, it looks like it uses wifi. Do you know if they have an API for it? If so, someone could potentially make a nodeserver for it. You could also potentially use network resources to control them

Glad I swapped out my Google homes and Alexa with Sonos ones

Post your program

They have not quit. With limited stock coming in, they are selling through their own store vs. Amazon

Sounds like it works outside of the Isy so it must be something you've programmed inside of it. My guess, is the button is in non toggle off mode and needs to be put in toggle mode

Did you do what I said in regards to troubleshooting? The Kpl of obsolete so you may be better off just saying it out for a new one

What's the model number