bgrubb1

update broke me as well SSH still works ticket in

3 days later it works no idea why

bingo all good again tu

well I would restore to 5.5.4 but suspect its something in the packages

I am on Polisy not Eisy have rebooted no change Do not run Nodelink does anyone have the ability to test on 5.5.5 ? ...Barry

or maybe post 5.5.5 upgrade

I installed Envisalink HW last Saturday on PG3 everything worked flawlessly. Yesterday the PG3 Node Server threw a cant connect to envisalink at 192.168.1.155 (the reserved address) I can ping it, and I can login to it at that address with browser / password is default Tried removing the Node Server and re-installing, same failure I can see alarm from the app It may have been when I upgraded to 5.5.5 on IOX Polisy with Zmatter Any other ideas ?? log attached ...Barry EnvisaLink-HW_2-7-2023_35933-PM.zip

i have plenty of devices and scenes that transfered and work well I just cant seem to add a new one post migration

really Have asked alexa, have used alexa.amazon.com and the app Suspect it has something to do with my move to IOX on polisy last weekend

I added a few devices in the portal and Amazon does not discover them

Soooo. I have 4 Polisy's I manage that have the Zmater board installed. The one that I did the Zwave migration works great. The other 3 have the Zmatter Zwave not responding message Maybe try the Zwave migrate to see if it enables it ???

does bitstring get installed with the LIFX node server install ? I tried updating before installing LIFX and bitstring is not installed

I have been looking for a step by step as well to move insteon and zwave both to polisy / zmatter. ...Barry

Buhler ??

Is this the correct procedure to migrate ALL aka insteon, network resources, portals etc ?

use port 8080

If I read the conversion announcement for 5.5.2 zwave, it doesnt mention the restore of Insteon to the Polisy / eisy Is there a conversion process to follow before the zwave conversion ?

dont use 8080 for SSH use the default (think its 23)

So if planning to migrate a 994 / node servers to a polisy with Matter should I prep a polisy first to IOX 5.5.0 ?

there is a new item on the UDI store page which appears to meet your need

I use the color touch as well. you can set the delta temp. I have mine set to 2 degrees

second ticket fixed the issue. All good and easy fix

Well been there done that to no avail, thus asking the forum

I opened a ticket a week ago [Ticket #19457] due to 3rd light flashing. I was hoping I could recover my existing node servers so would like to know if the flash chip available from support could fix instead of replacing the SSD. I have not received a response to my ticket and PMed Michael to no avail. Anyone on the forum have a suggestion ?? ...Barry

Hijacking the thread I have 4 installations I am planning on upgrading to Zwave/Matter Polisy from 994 3 have 500 series Zwave. 1 still has 300 series. Can I migrate 1, clear the 500 board, migrate last to 500 series, then Migrate to Polisy ?