tmorse305

The MS was in linking mode prior to the write attempt. Here are the screen shots you requested.

Jumper #5 is set for software control. Here is the Event Viewer dump: Sat 09/12/2015 08:33:02 PM : [All ] Writing 0 bytes to devices This single entry occurred after I tried to update an option

The only dual band device currently connected to the ISY is the PLM itself. The MS is about 6ft away from the PLM. Since I can read the motion, dawn/dusk and battery status I figure i was close enough. The HouseLinc is also connect via a USB PLM. I have many dual band devices in my house but I haven't linked any of them to the ISY yet. I was starting small just to get the feel of the ISY.

I just purchased an ISY994i IR PRO to replace a Cortexa (and some HouseLinc) automation controller. So I'm new to ISY but not home automation. I have a new motion sensor that I bought and have linked it to the ISY, it's the only device linked. I factory reset the sensor prior to linking and it is working correctly reporting both motion, dawn/dusk and battery(off) to the ISY. The problem comes when I try to modify the option settings. I set the led flashing on the MS then click the options button and I get an error message "Request Failed". Once the Option screen is open I click the query button but get the same error message. I linked it to my Houselinc software just to make sure the MS is working. From the Houselinc I was able to set to the options. So I think the MS is OK. Any suggestions? Thank you.