sbex55 Posted November 16, 2013 Posted November 16, 2013 Hello. I'm having a problem with a KeypadLinc I recently installed. I placed an 8-Button Dimmer (2334-2 V .43) on my wife's nightstand. I linked and programmed one of the buttons (G) to an ApplianceLinc to control her table light. This has worked reliably. My problem is when I try and use another button to control a device connected to my Elk security panel. Here is the program I use: If Control 'Dar Keypad F' is switched On Then Set Elk Audio 'Master Bedroom' 'ITouch' Volume Up Else - No Actions - (To add one, press 'Action') When I press the "F" key it doesn't do anything. When I push the "F" key again (typically) it makes a long beep sound and then the entire keypad stops working. Sometimes not on the second press of the "F' key but eventually it happens. I then have to reset the keypad and re-link it. Either my program is screwing this keypad up or it's defective. Any help would be appreciated.
oberkc Posted November 16, 2013 Posted November 16, 2013 I am unaware of anything that any program (or any other ability of the ISY) can do that would cause a keypad to emit a long beep and then to stop working. If you wanted to be sure, you could disable or delete the program and see if this solves the problem. Another thing I would do is watch the event viewer when pressing the F button. Does the ISY see it? Loose wire? My guess at this point is faulty device.
davbow Posted November 16, 2013 Posted November 16, 2013 You should try to reset the device and see what happens.
Recommended Posts