I have a dimmer switch where once the power is applied (breaker turned on) it just blinks green. Eventually there will be the long beep but afterwards - the LEDs don't move - always stays lit at the bottom as if off. I have tried the hard factory reset but no change.

 

Thanks

Ray

54 minutes ago, raymondjiii said:

I have a dimmer switch where once the power is applied (breaker turned on) it just blinks green. Eventually there will be the long beep but afterwards - the LEDs don't move - always stays lit at the bottom as if off. I have tried the hard factory reset but no change.

 

Thanks

Ray

What procedure did you use to factory reset your device

5 minutes ago, lilyoyo1 said:

What procedure did you use to factory reset your device

Pulled out the tab at the bottom, let it sit for about 30s, push in and keep pushing in (don't let it slip) until the long beep stops.

18 minutes ago, raymondjiii said:

Pulled out the tab at the bottom, let it sit for about 30s, push in and keep pushing in (don't let it slip) until the long beep stops.

If everything is wired correctly, is disconnect the red wire and see if the behavior changes

1 hour ago, lilyoyo1 said:

If everything is wired correctly, is disconnect the red wire and see if the behavior changes

I'll try it but I can tell you that the load, which is a dimmable LED light that goes to a Panasonic bathroom fan, has been removed. I actually never had a load on this switch since the day I bought it used - so my guess is that it's toast. ISY994i does discover it and link it but trying to turn it on and off - no go.

Long shot here. Try it with the paddle removed on the chance it is pushing on the off button all the time.

From your description another thing could be its bower supply is failing. Can you talk to it with the ISY994i?