Monday at 07:23 PM2 days Hello all, Programming with the EISY-UI, can someone direct me to the menu area where the Insteon motion sensor options are located? Such as sensitivity and the timing reset values. Thanks,Mike
Monday at 08:50 PM2 days Right click on the icon to the left of the motion sensor's name, then click on Configuration > Options Edited Monday at 08:52 PM2 days by Techman
Monday at 09:45 PM2 days Following Techman's instructions - left click at the icon, select "Configuration":Then, right-click the "Options" gear-icon and for older 2842-222 type:Pretty much the same for newer Motion Sensor II (2844-222):HTH! Edited Monday at 09:45 PM2 days by GPritchard
Tuesday at 01:54 AM2 days Author Thank you for responses ... I see the options button now, I tried it out but now I have another problem ... The Insteon sensors return "system busy", "504 error" and "API returned HTTP error 504" errors and all my Z Wave motion sensors have failed. I thank you both for the reponses... now I will submit a new post regarding my system failure. * edit : I just learned that all of my other Insteon motion sensors are now not working ... ugh...... Edited Tuesday at 01:57 AM2 days by mldoyle More information...
Tuesday at 07:05 PM1 day Is anybody else using Motion Sensor II (2844-222) and notice that settings don't show or adjust under options? All I see is "No LED" checked and nothing else, even if I change it. It always stays the same.
Yesterday at 01:07 PM1 day Yes, I notice the same. After I took the screenshots (above), I tried making adjustments to both my Motion Sensor (gen1) and Motion Sensor II.I cannot make any Motion Sensor changes to either generation. Essentially, my screenshots are perma-stuck as shown. @bmercier @Javi
Yesterday at 01:22 PM1 day Mine is similar. My 2844-222 (Motion Sensor II) does not respond to any options changes in EISY-UI. Even if it did respond, the options exposed in the Configuration>Options menu us significantly reduced from the options exposed in Admin Console:
Yesterday at 02:49 PM1 day Did you put the motion sensors into the linking mode before trying to update its configuration
23 hours ago23 hr I tried with a plugged in unit, I tried it in linking mode both plugged in and on battery. I tried it on other motion sensors.
22 hours ago22 hr Probably best to open a support ticket as there may be a bug in the eisy-ui firmware
21 hours ago21 hr This is a known issue for advanced insteon commands. Scheduled to be reworked. Until that time please use Admin Console for these adjustments.
Create an account or sign in to comment