Blackbird

They are no more than 5 feet away from the nearest switch or even the plm.

I meant a light for example. Out of the 5 motion sensors, only the 3 that blink, are not linked to a device like a light. Not sure if that is why

Thanks

I only have those 3 sending a notification and they are not linked to any other device.

I have 3 motion sensors that blink real fast I believe for about 10 seconds after movement is detected. I have the led brightness turned off in the isy settings but it still blinks. I have two others that work fine and only make a quick blink of light when motion is detected. All five have factory jumper settings and have the same settings in the isy. Any idea?

I have 3 motion sensors that blink real fast I believe for about 10 seconds after movement is detected. I have the led brightness turned off in the isy settings but it still blinks. I have two others that work fine and only make a quick blink of light when motion is detected. All five have factory jumper settings and have the same settings in the isy. Any idea?

Got it wired up and works great. Finally! Thanks guys for your help and convincing me to get the new switch

ok thanks

I chose the switch that was recommended that does nc and no

If polarity doesn't matter and Im not using the green wire, how do you choose between NC or NO on the switch?

994i non pro

I havent updated to lollipop yet and wondered if any of you have had problems with mobilinc.

Well I get it on Tuesday so I cant wait to finally resolve these issues

I would like my lights to come on fast but shut off slow. Is this possible?

I bought a fairly expensive label maker and I found that the nail polish remover worked great and with patients, my labels look very good. Just a warning, when putting labels on the 8 button mini remote, do not attempt to use nail polish remover as it ruins the finish and eats the plastic. Instead of clear labels for the remote, I used white labels.

So the benefit of the new switch, isnt because it has 3 wires but because of the design of the switch?

I didn't understand this part. "Tape Green wire. Trigger Reverse no longer used nor any Program to reverse Sensor state"

Any suggestions on how to wire the 3wire magnet switch to the io linc?

I asked the same question and guys told me they use the insteon indoor motion sensor, outside with no problem. I am making an enclosure to help keep the rain off it.

So what is involved in the setup with the vpn to get mobilinc to work?

So if you have a vpn like PIA, then mobilinc will work with all its functions without a subscription?

Will any of these be good? does it need to have normally open and normally closed? I was thinking about the first one. Smarthome wants to charge $30 shipping so im buying in Canada. Thanks https://www.aartech.ca/odc-59b-amseco-garage-door-magnetic-contact-form-c.html https://www.aartech.ca/odc-59a-amseco-garage-door-magnetic-contact.html https://www.aartech.ca/vip1000-98z-flair-overhead-door-contact-with-z-bracket.html https://www.aartech.ca/vip1000-98l-flair-overhead-door-contact-with-l-bracket.html

is that the standard switch that comes with the garage kit or is that a 3 wire switch?

Well I may have to listen to you guys. After my last change to my program, I did not receive my 3am email notification but at 730am I looked at mobilinc and as soon as I did I got the door open email.

I always thought you needed to mount it to the floor like most warehouses do