Blackbird

When you say it has to be saved and Enabled at the from time, do you mean I need to save and enable before that window of time starts or within the window of time?

"bedroom lights" is the name of the scene and the controller. Is that a problem to have both scene and controller named the same?

I lied, now the kitchen program doesn't work.

For some reason I could only get this to work with the kitchen lights. I changed the time to 221pm so I could test it. For this program the bedroom lights act normally. If I switch it to kitchen lights then the lights come on at 10% If From 2:21:00PM To 9:00:00AM (next day) Then In Scene 'Bedroom Lights' Set 'Bedroom Lights' 10% (On Level) Else In Scene 'Bedroom Lights' Set 'Bedroom Lights' 100% (On Level)

Yes

When I turn the bedroom lights on by the switch, between 10pm until 9am each day, I want the on level to be set to 5%. How do I achieve this? Thanks

Just did the same for the other two and problem solved. I don't know why but it works. Thanks guys for the suggestions

So this is interesting, I took one of the ms that was blinking and made it part of a scene for my kitchen lights. The blinking stopped and the MS worked fine. I then removed it from the scene and it still works fine for my notifications without the blinking.

They are no more than 5 feet away from the nearest switch or even the plm.

I meant a light for example. Out of the 5 motion sensors, only the 3 that blink, are not linked to a device like a light. Not sure if that is why

Thanks

I only have those 3 sending a notification and they are not linked to any other device.

I have 3 motion sensors that blink real fast I believe for about 10 seconds after movement is detected. I have the led brightness turned off in the isy settings but it still blinks. I have two others that work fine and only make a quick blink of light when motion is detected. All five have factory jumper settings and have the same settings in the isy. Any idea?

I have 3 motion sensors that blink real fast I believe for about 10 seconds after movement is detected. I have the led brightness turned off in the isy settings but it still blinks. I have two others that work fine and only make a quick blink of light when motion is detected. All five have factory jumper settings and have the same settings in the isy. Any idea?

Got it wired up and works great. Finally! Thanks guys for your help and convincing me to get the new switch

ok thanks

I chose the switch that was recommended that does nc and no

If polarity doesn't matter and Im not using the green wire, how do you choose between NC or NO on the switch?

994i non pro

I havent updated to lollipop yet and wondered if any of you have had problems with mobilinc.

Well I get it on Tuesday so I cant wait to finally resolve these issues

I would like my lights to come on fast but shut off slow. Is this possible?

I bought a fairly expensive label maker and I found that the nail polish remover worked great and with patients, my labels look very good. Just a warning, when putting labels on the 8 button mini remote, do not attempt to use nail polish remover as it ruins the finish and eats the plastic. Instead of clear labels for the remote, I used white labels.

So the benefit of the new switch, isnt because it has 3 wires but because of the design of the switch?

I didn't understand this part. "Tape Green wire. Trigger Reverse no longer used nor any Program to reverse Sensor state"