bgrubb1

Resolved here too thanks Michal and a ticket. issue was a file set to update to quarterly, not latest. Suspect this occured when there was an update failure a couple of years ago when some of us changed the file to get back up

@Bumbershoot Cam you elaborate on I upgraded my Polisy and None of my plugins connect. re-install doesnt help

quote So the Poisy system and all programs is essentially totally non-functional. How can I recover the Poisy and its programs to its correct operating state? The policy has lost its ability to establish a DHCP address and only has access from Cloud AC. The polisy must be doing DHCP if it could not connect to internet cloud would not work

open each program press update then press save

I am not sure on this, but would think the number should be Hexadecimal ie. 256, 512, 1024, 2048 Not decimal ie. 1056

- If the admin console is slow to respond, it is likely you need to increase the amount of memory allocated to the Java runtime (JRE). - Open the Java Control Panel, select Java tab, press View button, then add or modify the Runtime Parameter -Xmx to the following: o -Xmx512m - Press Ok to close the window, then Press Apply to save the changes

Reboot doesnt seem to work right on Polisy Unplug and plug back in

make sure you click "update" and "save"

I dumped the inseon leak detectors and went with Yolink much more reliable, report battery low and last forever

Looking to add an LED floor lamp. Govee is lots cheaper, but the plugin does not support Anyone have one ??

Did anyone on 5.0.7_5 have the disable program issue ?? I was and did not

I added Both the Yolink Garage dor sensor and the Yolink Garage door opener. IOX allows monitor as well as open / close

you could save them then disable them

@RichTJ99 Did you open EVERY program and save it and EVERY Network Resource and save it post migration per the instructions ?

if as you say, its a NVR and connected to a DVR you will need to adress the DVR In my case I had to enable on the DVR then... rtsp://username:password@DVR.IP.Address:554/chID=1&streamType=main&lnk-Type=tcp Also notice Linux is case sensitive

upgraded 2 Polisy's tonight still have the issue that power off reset required to update IOX else all good

Upgraded 2 Polisy's this morning Both now at 13.2 and 5.0.7_4 Only issue was had to power down reboot both after attempting AC reboot

Pretty sure Nodelink has never worked with Polisy or Eisy (TCP/IP stack compatibility issue) I have Venstar and it works great under PG3X on the Eisy

is the disabled programs fixed in next upgrade before I attempt and go through this ?

I had a similar failure Replace the power supply

I tried to purchase the free wemo NS red error box saying failed and returned me to purchase page

@sjpbailey @bmercier I just tried installing one and it errors out on purchase ...Barry

just a note I upgraded 3.2.2 to 3.2.3 no issues (on a Polisy) ...Barry

why don't you switch to UDmobile ?? great app and fully supported works on IOS and Android and supports 994 and Eisy

Admin Console is very slow or hangs If the admin console is slow to respond, it is likely you need to increase the amount of memory allocated to the Java runtime (JRE). Open the Java Control Panel, select Java tab, press View button, then add or modify the Runtime Parameter -Xmx to the following: -Xmx512m Press Ok to close the window, then Press Apply to save the changes