ISY not allowing Admin Console to save Z Wave action in program

[RichK52]

I recently purchased 2 GE/Enbrighten Z-Wave Outdoor Smart Switches since Insteon products are not available. 

After adding them to the Admin Console (6+ devices showed up for each smart switch), I tried to write 2 programs to turn the switches on and off at Sunset & Sunrise.  The system let me add the 'Off' action, but will not allow me to add the 'On' action.

 

[lilyoyo1]

Firmware and UI

[DennisC]

Why use two programs? On and off is easily accomplished with one program. Use the time option from - to. Don't forget to use the next day option for sunrise.

[RichK52]

I believe I am running the latest firmware -v5.3.0. No beta,

Edited December 22, 2021 by RichK52

[RichK52]

Dennis, I have never been able to get a single program to work that will turn a light off at sunrise and turn it on at sunset. So, I finally said 'uncle' and applied the KISS strategy and created 2 separate programs.

[lilyoyo1]

25 minutes ago, RichK52 said:

I believe I am running the latest firmware -v5.3.0. No beta,

I'd upgrade to 5.3.4. Clear your Java cache, and make sure you use the launcher from the post.

[DennisC]

8 hours ago, RichK52 said:

Dennis, I have never been able to get a single program to work that will turn a light off at sunrise and turn it on at sunset. So, I finally said 'uncle' and applied the KISS strategy and created 2 separate programs.

I agree with the previous poster that you should upgrade to the latest version,5.3.4. You should also try rebooting your ISY and see if that clears up your saving issue.

Don't understand why you are having issues controlling from sunset to sunrise for on/off control. I have numerous programs written that way.

Are you sure you have checked the box for sunrise that says next day? 

Do a search for ISY Cookbook, there are examples in there on writing programs.

Good luck.