can you send a debug log.  i am guessing otherwise

can you send a log file

this is what my mobile app shows

 

I didn't do an update.  I put it in the same slot as the previous, but completely different Tesla node was.  Then did a fresh install of the new one.

I just drove the car and it currently shows good data.  I will see what happens in a bit and send a log.

Is it acceptable it I only allow update Data (button) on the status page?  It will update data on all pages, but will be a much simpler to implement 

 

link is bad and is: ttps://github.com/Panda88CO/udi-TeslaEV2/blob/main/README.md

yes, missing an h at the beginning

I cannot find the bad link - which one are you referring to? I'll try to fix it

@Panda88 I think it’s the “more info” button on the plugin page. When viewing on a mobile device it asks me if I’m trying to open another app. 

it does not show in the released note but there have been some updates that did not populate so it may be an older version

5 hours ago, Geddy said:

@Panda88 I think it’s the “more info” button on the plugin page. When viewing on a mobile device it asks me if I’m trying to open another app. 

Yes.  Thanks for clarifying my comment.  Its the more info button.

I have updated to the latest version and this still is not working.  My car is currently charging and the phone app shows it as charging and currently 75%.  This is what the node says.  I assume "status" should be saying 75%.  And of course the other info should be saying it is charging.  If I click "honk horn", it does honk the horn.  So clearly it is connected in some fashion.

And the climate page shows 0 degrees c in the "node connected" field.  That makes no sense.  My phone app shows exterior temp as 81 and interior temp as 92.  

 

EDIT:  After a bit, not sure how long, it did update to say it was charging, but still reporting 0% status.

 

Edited December 29, 2024Dec 29 by apostolakisl

can you send me a log file?

can you send me a log file?  what version is it reporting?

@apostolakisl:  I had a similar problem recently where none of my data was updating.  I was able to fix it by using the "autheticate" button in PG3x and this fixed the issue.  

I updated the node today and now I am getting an accurate percent on the battery.