SHM

I have a 2 year old Polisy Pro connected to ISY 994 ZW, version 5.3.4. All has been working well. Recently, I activated the wireless side of the pro and also upgraded the ISY launcher for another site which I have migrated ISY to Polisy successfully. Now, the Polisy Pro goes through a repeating cycle of single left LED on to 3 beeps, then all LEDS flashing, then a beep, then 2 LEDS flashing, then just the left LED on. This repeats every 45 seconds or so. I cannot communicate with the Polisy either thru LAN or WAN. Have tried the factory reset on the front on the Pro, but no effect. I am planning to migrate this Pro to IoP soon (waiting for the data board). Any ideas?

Just completed migration to IoP and am in the process of adding back my Z wave nodes to the Zooz 700 dongle. My Baldwin door lock will be recognized on the add command but it fails per the attached message. It worked fine on my ISY 994. I have gone thru the firmware update for the dongle, to no effect. Any ideas?

Your suggested program works great. I should have anticipated the garage door closing delay.

By the way, the MYQ node server on Polisy has a door "state" option, so I went with that

I'll give that a try. My goal was to use Pushover to send a message to my phone telling me that the garage door successfully closed after leaving the geofence

The program goes like this: If SHM_Geofence =0 AND SHM_Tahoe =1 AND 'vashon2/ east door' state is open THEN SET vashon2/ east door' close Resource 'vashon east door' A jpeg of the network resource is attached

My ISY sends Pushover a notification that my garage door has closed. For some reason, I am now getting 3 Pushover notifications for each closure. Pushover suggest that their API is getting 3 messages. Any thoughts?

Nothing works

Hmmm.. Did that but now Safari says it can't find the server. Have tried http://polisy, the LAN and WAN IP's

All of a sudden, cannot log in to my Polisy (LAN or WAN). Nothing happens after entering password. I have tried power cycle. Suggestions?

Long time user of ISY/portal/polisy. I have many programs that turn lights on, open doors depending on geofence status and iBeacon status, which update state variables. Using Mobilinc Pro, 4.17 on iPhone 13, 15.1.1 but have lost geofence and iBeacon updates to ISY state variables, so my programs won't run. Suggestions?

OK

Just downloaded UD Mobile to my iPhone and configured to my ISY. When I follow the instructions to add a Geofence, I get as far as generating a 6 digit code, but when I open UD Mobile, there is no place to add it. Suggestions? Locations on the app are enabled.

Solved by using the latest Admin console! Works great. No issues.

Did not unzip file either

yes

Trying to migrate from 5.3.1 to 5.3.3 but after 20 seconds or so, during loading of /code/455/hex it stop giving error message: "reported written size is invalid" Suggestions?