GnuseJay Posted December 25, 2017 Posted December 25, 2017 I am unable to connect to my Smoke Bridge. It is listed in the devices, but it gives me a message that it cannot determine the Insteon Engine xx.xx.xx INSTEON Smoke Sensor v.00 - Cannot determne Insteon Engine Any suggestions?
Michel Kohanim Posted December 25, 2017 Posted December 25, 2017 Hi GnuseJay, This is usually related to signal/noise issue. You might want to move the PLM to a different outlet and one which is not shared with other transformers and power supplies. With kind regards, Michel
stusviews Posted December 27, 2017 Posted December 27, 2017 If you find that powering the PLM from another outlet is successful, then you need to consider that something on the original circuit is causing line noise and should be filtered to minimize the probability of future problems. At that point, you can safely plug the PLM into the original place.
GnuseJay Posted December 30, 2017 Author Posted December 30, 2017 I moved the PLM to a separate outlet. I get the same results.
paulbates Posted December 30, 2017 Posted December 30, 2017 Did you try using the "Start linking" option, and then put the smokebridge in linking mode? Its been a while since I had this device, but my recollection was I had to do it that way Paul
Recommended Posts