Jump to content

Enabling Z-wave module using UD mobile


MBell
Go to solution Solved by Javi,

Recommended Posts

Most likely very few users would notice, but I believe I found a couple of bugs.

#1

When enabling Z-wave module using UD mobile it somehow disabled the Insteon module that has always been enabled. I had to utilize the admin console to figure out why my Insteon devices were not responding. Found the Insteon module not selected directly after enabling the Z-wave module using UD mobile.

#2

When disabling Z-wave module using UD mobile, it crashes the entire Insteon network. To get the Insteon network back up and running correctly, you have to re-start IOX, and then query all Insteon devices.

Setup - Polisy running 5.59, PG3 version 3.120 UD mobile IOS

This is not a big deal as it is easily resolved, just thought I would pass this along.

Thanks,

Edited by MBell
spelling
Link to comment
On 4/22/2023 at 10:12 AM, MBell said:

Most likely very few users would notice, but I believe I found a couple of bugs.

#1

When enabling Z-wave module using UD mobile it somehow disabled the Insteon module that has always been enabled. I had to utilize the admin console to figure out why my Insteon devices were not responding. Found the Insteon module not selected directly after enabling the Z-wave module using UD mobile.

#2

When disabling Z-wave module using UD mobile, it crashes the entire Insteon network. To get the Insteon network back up and running correctly, you have to re-start IOX, and then query all Insteon devices.

Setup - Polisy running 5.59, PG3 version 3.120 UD mobile IOS

This is not a big deal as it is easily resolved, just thought I would pass this along.

Thanks,

Hi @MBell,

Thanks for the report.  I tried but cannot replicate the issue.  Are you using the Z-Matter module or Zooz USB stick?

Update: Replicated.  Looking for cause

Link to comment
Guest
This topic is now closed to further replies.

×
×
  • Create New...